Sweep & inspection
Caps & crowns
Flue relining
Masonry repair
Gas fireplace serviceLevel 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
Chimney Company in Texas City, TX
Chimney repair in Texas City starts with understanding what the houses here actually have: small masonry fireplaces and exterior brick chimneys built for refinery and dock families in the 1940s through the 1970s, then left to decades of salt air and Gulf humidity. Those chimneys weren’t built for heavy burning, and time has done more damage than any fire ever did. We work on them every week. The problems we find most are spalling mortar crowns, rusted dampers, and cracked clay flue tiles – not creosote alone.
If your chimney has sat unused through several mild winters, the first cold front is when trouble shows up. Call (866) 819-7336. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday, and our technicians have up to 15 years of experience.
Why Texas City Homes Are Different
Texas City sits in the middle of the Gulf Coast petrochemical corridor, and its housing stock grew up around that work. The older single-story brick ranches and bungalows in 77590 and 77591 were built for refinery and dock families, and their fireplaces are small masonry units with clay flue tiles, aging dampers, and exterior brick stacks fully exposed to salt-laden coastal air. That exposure is the real driver here. Soft Gulf-coast brick and mortar crowns fail faster than they do inland, dampers seize with rust, and flashing pulls away from a roof that gets hammered by hurricane-season wind-driven rain.
Storm season also makes the chimney one of the more vulnerable penetration points on the whole house: missing caps let rain straight into the flue, and tall stacks on this flat coastal plain are the high point on the roofline when lightning comes through. Add years of dormancy between rare cold snaps, and you get chimneys that need an inspection before the first burn, not just a routine annual sweep.
Styles & brands we work with
- Sweep & inspection
- Caps & crowns
- Flue relining
- Masonry repair
- Gas fireplace service
Our Main Texas City Services
Most Texas City homeowners call us for one of two things: the chimney needs cleaning, or the dryer is taking too long and the vent is suspect.
Chimney Sweep in Texas City
A sweep here means more than brushing a flue. Chimneys in Texas City often sit unused for years, so we open the firebox, check the damper, look up the flue with a camera, and pull out what accumulated while nobody was burning – bird nests, leaves, and the gritty debris coastal humidity leaves behind. We also look hard at the flue tiles and the crown, because a sweep is the moment those problems get caught. Everything we find comes with photos and a written report. If you want the full rundown on what a visit includes, see Chimney Sweep in Texas City.
Dryer Vent Cleaning in Texas City
Dryer vents clog faster in humid coastal air because lint sticks to slightly damp duct walls and builds up in layers. When a dryer in Texas City starts taking two cycles to finish a load, the vent is usually the reason. We run the full line from the dryer to the outside hood, clear the lint, check the transition and the exterior flapper, and confirm the duct isn’t crushed or routed with a long sagging run that traps debris. It’s the fire risk most chimney-only companies never look at. Full details live on our Dryer Vent Cleaning in Texas City page.
Chimney Repair in Texas City
Chimney repair is the work Texas City asks for most, and the local housing explains why. The mid-century brick homes in 77590 and 77591 have masonry chimneys with soft coastal brick, clay tiles, and original dampers that have spent decades in salt spray and humidity – so crowns crumble, dampers rust shut, and flue tiles crack without anyone ever lighting a fire. Our Chimney Repair work starts with inspecting and identifying the actual failure, then fixing that specific thing rather than recommending everything at once.
Chimney Crown Repair
Signs you need it
You’ll see chunks of mortar on the roof or in the yard, a crown that has pulled away from the flue, or water staining on the firebox ceiling after a hard rain.
What it costs in Texas City
Most crowns run around $300 to $700, with a full reconstruction on a badly failed crown landing near $1,000.
How we do it
We chip off the failed mortar, form a proper slope away from the flue, and pour or trowel a crown mix that can handle Gulf-coast sun and rain.
Chimney Cap Installation
Signs you need it
The flue is open to the sky, rain gets in during storm season, or birds and squirrels have found their way down the stack.
What it costs in Texas City
A single-flue cap typically runs about $200 to $400 installed, and multi-flue or custom caps fall in the $400 to $800 range.
How we do it
We measure the flue opening, fit a stainless or copper cap from a line like Olympia Chimney, and anchor it to the crown so wind-driven rain and wildlife stay out.
Chimney Liner Installation
Signs you need it
Cracked or missing clay tiles show up on camera, or a new appliance needs a correctly sized flue that the old chimney can’t provide.
What it costs in Texas City
A stainless liner installation usually runs $2,500 to $5,000 depending on height and flue condition, with cast-in-place resurfacing in a similar $2,000 to $6,000 range.
How we do it
We camera the flue, clean and prep it, then either insulate and drop a DuraFlex stainless liner or resurface the existing tiles with HeatShield, depending on what the chimney can actually take.
Chimney Flashing Repair
Signs you need it
Rust streaks on the chimney brick, a water stain on the ceiling near the stack, or flashing that lifts easily when you press on it.
What it costs in Texas City
Flashing repair generally lands between $350 and $800, and a full flashing rebuild where the old material is shot runs $600 to $1,200.
How we do it
We remove the failed flashing, cut new counterflashing into the brick, and seal it with proper step and apron pieces so hurricane-season rain sheds away from the stack.
What Chimney Repair Costs in Texas City
These are typical estimates, not quotes. The written estimate you get after inspection sets the final price, and nothing gets added afterward.
| Item | Typical range in Texas City |
|---|---|
| Chimney crown repair | $300 – $700 |
| Chimney cap installation | $200 – $400 |
| Chimney flashing repair | $350 – $800 |
Does chimney repair in Texas City need a permit?
Some repairs do, some don’t, and it depends on your city’s building department. Structural work like a crown rebuild or liner installation usually requires one; a cap swap typically doesn’t. Ask before the work starts, and we’ll tell you what the job involves so you know what to ask.
Can you repair a chimney that hasn’t been used in years?
Yes, and that’s common here. Dormant chimneys usually need a camera inspection first, since rusted dampers, cracked tiles, and nests show up before creosote does. We identify what’s actually wrong, show you the photos, and fix only what needs fixing.
Brands We Service in Texas City
We work with professional-grade brands because the job calls for them: Olympia Chimney and Copperfield for venting and hearth components, Famco where its products fit, and DuraFlex for stainless liners. We don’t claim to stock parts locally, but these lines keep sourcing straightforward, which helps turnaround on most Texas City repairs. You can see the full lineup on our brands page.
See the difference
Before
After
Before
After
Before
AfterPricing for Chimney Company in Texas City, TX
| Service | Typical range in Texas City |
|---|---|
| Chimney sweep | $150 – $350 |
| Dryer vent cleaning | $120 – $250 |
| Chimney crown repair | $300 – $700 |
| Chimney cap installation | $200 – $400 |
| Chimney cap replacement | $200 – $500 |
| Chimney flashing repair | $350 – $800 |
| Flashing rebuild | $600 – $1,200 |
| Chimney liner installation | $2,500 – $5,000 |
| Liner resurfacing (HeatShield) | $2,000 – $6,000 |
What pushes price up in Texas City is access and condition: a tall exterior stack, a crown that needs full reconstruction, or flashing that has to be rebuilt into soft coastal brick all add time and material. The written estimate you receive before booking is the number that holds – no surprises added later.
Neighborhoods We Serve in Texas City
We cover the whole city, from the older brick streets near the refinery corridor to the newer subdivisions on the edges of town. Homes in the older parts of 77590 and 77591 tend to need the most masonry evaluation, simply because those chimneys have been taking salt air the longest. Dispatch runs from 7am to 7pm, Sunday through Friday, and we’re closed Saturday.
- Downtown Texas City
- Northside
- Mainland
- West Texas City
- The subdivisions off Highway 146
Service Area – Cities Near Texas City
Texas City shares the same coastal conditions with the towns around it, so the work doesn’t change much as you move along the bay. We also serve La Marque, TX, Hitchcock, TX, Dickinson, TX, and Bacliff, TX, along with League City, where our home base sits. If you’re just outside the city line and not sure whether you’re covered, call and we’ll confirm.
Serving Texas City, TX – Our Local Coverage Area
We serve Texas City and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
FAQs About Chimney Company in Texas City
Dispatch runs from 7am to 7pm, Sunday through Friday, and we book you into the soonest opening rather than promising a window we can’t hit. Same-day service is often possible. Call (866) 819-7336 – we answer 24/7 – and we’ll get you scheduled.
Structural chimney work usually needs a permit from the city’s building department, while simple maintenance like a sweep or cap swap typically doesn’t. If you’re in an HOA, check whether exterior changes to the chimney or roofline need approval. Ask before the work begins.
We cover the entire city, including both 77590 and 77591, from the older neighborhoods near the water to the newer subdivisions inland. If you’re on the edge of town or just across the city line, call (866) 819-7336 for a free estimate and we’ll confirm coverage.
Whether the chimney needs a crown rebuilt, a cap fitted, or a liner installed, the first step is the same: inspect it, identify what’s actually failing, then fix that. Call (866) 819-7336 for a free estimate. We answer 24/7, with fast dispatch from 7am to 7pm, Sunday through Friday.
What happens when you call
- 1A real person answersNo phone trees. Talk to a local chimney cleaning pro.
- 2You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
- 3We come out and measureLicensed & insured, at a time that suits you. The visit and the quote are both free.
- 4You get the price in writingLine-itemed, yours to keep, and nothing starts until you say go.
What Texas City Customers Say
"Level two inspection before we bought the house. The report was detailed enough to use as a negotiating point and he explained every photo in it."
- Sarah Gallagher"Thorough sweep and a clear report. He was running late from the job before and arrived near the end of the window, though he did call to warn me."
- Ruben Delgado"Good work. The written inspection report took about a week to arrive after I asked for it, which was slower than I expected."
- Maria Garcia